December 2016
Columns
Reliability: Troubleshoot hot bearings in hot pumps
The reliability engineering unit supervisor (REUS) working at a 400-Mbpd refinery wrote that he was greatly concerned about a bearing temperature excursion. He realized that certain rules of thumb had been handed down to his maintenance employees, and that not all of these conveyed the same numbers and guidance.
The Author
Heinz P. Bloch resides in Montgomery, Texas. He retired as Exxon Chemical’s Regional Machinery Specialist for the U.S. and has authored or co-written more than 780 publications, among them 23 comprehensive books on practical machinery management, failure analysis, failure avoidance, compressors, steam turbines, pumps, oil mist lubrication and optimized lubrication for industry. Mr. Bloch holds BS and MS degrees (cum laude) in mechanical engineering from the Newark College of Engineering (NCE). He is one of 10 inaugural inductees into NCE’s Hall of Fame, which honors its most distinguished alumni.
Related Articles
- Design an efficient and cost-effective system for corrosion deterioration mechanism diagnosis and detection planning
- Transform gas metering and pipeline monitoring through digitalization: Is hydrocarbon dewpoint a dependable metric?
- Trade-off analysis between fired heater safety logic and operability: Challenges of excessive safety instrumentation
Comments