US EPA, Canyon Plastics come to agreement about Clean Water Act violations
LOS ANGELES — The US Environmental Protection Agency has reached an agreement with Canyon Plastics, Inc. to resolve federal Clean Water Act violations. The company has corrected the deficiencies found at its facility in Valencia, Calif., and obtained a stormwater permit. In addition to paying a $19,000 penalty, Canyon Plastics has committed to install new recycling equipment at a cost of $292,000.
Canyon Plastics uses large quantities of small plastic pellets, known as “nurdles,” as raw material to manufacture plastic products. During a September 2015 inspection, EPA found the facility did not have a permit to discharge industrial stormwater and had not implemented practices to reduce the discharge of pollutants to local waterways. The inspectors found leaked or spilled nurdles throughout the facility’s waste management area and loading docks, and a lack of containment systems such as mesh screens within storm drain inlets. These deficiencies likely resulted in nurdles polluting Halsey Canyon Creek, a tributary to the Santa Clara River.
As part of the settlement, Canyon Plastics will spend $292,000 to purchase and install new equipment that will recycle plastic scraps generated at its facility and use them as raw material for some of its product lines. The new reuse system will reduce the purchase of new plastic by an estimated 270 tpy.
Under the Clean Water Act, plastic manufacturers are required to obtain authorization under the State’s industrial stormwater permit to discharge stormwater to surface waters.
Comments